Mon | Closed |
Tue |
9:00 AM 2:00 PM |
- |
12:00 PM 4:00 PM |
Wed |
9:00 AM 2:00 PM |
- |
12:00 PM 4:00 PM |
Thu |
9:00 AM 2:00 PM |
- |
12:00 PM 4:00 PM |
Fri |
9:00 AM |
- |
12:00 PM |
Sat | Closed |
Sun | Closed |
Do you have any questions about the product, installation, delivery or payment? Our friendly and competent service is at your disposal
e-mail
info@maritimusboote.de
Phone number
+49 (0) 38231 402934
to disposal.
Friends / followers / pictures
Facebook: MaritimusYachting
twitter: MaritimusBoote
Picasa Web Albums: Maritime Boats
Skype Internet Phone Name:
maritime_boats
Replaced by Sigma EcoFleet 530
The self-polishing antifouling long-term from the USA, environmentally friendly and highly effective. Tin-free.
AWLSTAR GOLD LABEL Awlgrip should to - be applied primer - HULLGARD ER. Order directly on the most rigid and self-polishing antifouling paints (but not on Teflon and tin!) Possible.
Sanding before the subsequent coat is not necessary.
It makes sense economically and it is, as a primer to apply two to three coats, then AWLSTAR GOLD LABEL also effective for several years.
Product Components, Reducers, Additives, and Auxiliary Components
Black BP241
Light Blue BP541
Dark Blue BP542
Red BP741
Shell White BP841
Reducer T0101
Equipment Cleaning T0101 Reducer or M.E.K
Application Equipment
Airless spray, Airmix, Brush, Roller
Airless Equipment Pressure Pot:
Graco or Binks equivalent:
Fluid Nozzle: 2.2 ( .089”)
Pressure: 175 bar – 207 bar
Tip Size 2180
Surface Preparation
New Applications: Prime with Hullgard Epoxy Primer D6070/D3707. Apply the first coat of Awlstar Gold Label (EU) according to recommended recoat times (see Hullgard Epoxy Primer Product Datasheet).
Existing Antifouling that is incompatible or unknown: High pressure fresh water wash as soon as the boat comes out of the water, allow to dry. Remove any loose paint or residue. Prime with suitable primer. Apply the first coat of Awlstar Gold Label (EU) after the primer has cured to recommended intervals.
Renewing Awlstar: High pressure water wash as soon as the boat comes out of the water, allow to dry. Wet sanding (80 grit) / removal of old coating is not normally required but is advised under any of the following conditions:
- Any time the cleanliness of the surface is in doubt. - Fast boats which have ablated to a very smooth surface.
- Sailboats which were recently burnished. - The surface was not power washed immediately after hauling.
Mixing & Reduction
Check for settling, then thoroughly mix until a consistent homogenous blend is obtained. Power mixers or shakers are preferred. If not available, thorough hand mixing is acceptable.
Reduction is not normally recommended. However, if needed for spray equipment or brush/roller application, 10% or 12 oz. (400ml) per gallon with T0101 is a recommended maximum reduction.
Induction Time after Mixing: N/A
Anticipated Pot Life at 75°F / 25°C 50% R.H.: N/A
Application Instructions
Awlstar Gold Label (EU) can be applied by airless spray, brush, roller, or airmix. For brush/roller, apply heavy coats of 4 mils (100 microns) WFT per coat, yielding 2.4 mils (60 microns) DFT per coat. For spray application, apply heavy coats of up to 8 mils (200 microns) WFT per coat, yielding 4.8 mils (120 microns) DFT.
For maximum antifouling performance and protection apply a minimum of 2 coats of Awlstar Gold Label (EU) Antifouling by brush/roller.
Optimum performance is achieved at a total dry film thickness of 4.8 mils (120 microns) minimum.
Extra protection and more uniform wear properties result when 1 extra coat of Awlstar Gold Label Antifouling is applied to high wear areas.
Warning: Important, Awlstar Gold Label (EU) Antifouling must not be used on aluminum.
Do not apply paint materials to surfaces less than 5°C (41°F) above dewpoint or warmer than 35°C (95°F). Ambient temperature should be minimum 5°C (41°F) and maximum 35°C (95°F).
The information in this Product Data Sheet is not intended to be exhaustive. Any person using the product without first making further enquiries as to the suitability of the product for the intended purpose does so at their own risk and, to the extent permitted by law, we can accept no responsibility for the performance of the product
or for any loss or damage arising out of such use. The information contained in this Product Data Sheet is liable to modification from time to time in the light of experience and our policy of continuous product development.
Product | Note | Status | Price | ||
---|---|---|---|---|---|
|
1,142.00 € * | ||||
|
|
30.90 € * | |||
* Prices incl. VAT, plus Shipping
Display accessory details
|
|
|
|
|